Nintendo Wii
Use
a metal spudger to remove the white plastic screw covers stuck to the lower
case near the front of the Wii.
Remove
the two 8.3 mm Tri-Wing screws hidden under the covers you just removed.
Remove
the single 5.9 mm Phillips screw under the controller port door nearest the
faceplate.
Use
a metal spudger to remove the rubber foot stuck to the side of the Wii near the
DVD drive opening.
Remove
the single 5.9 mm Phillips screw hidden under the foot you just removed.
Carefully
pull the faceplate away from the front of the Wii. Use a pair of tweezers to
disconnect the LED cable's plastic connector from the motherboard. Remove the
faceplate.
Open
the controller port cover until it is perpendicular to the black controller
port bezel. Pull the controller port cover straight up to release it from the
outer case. Repeat this procedure for the memory card port cover.
Remove
the two remaining 4.1 mm Phillips screws along the top edge of the black
plastic controller port bezel. Lift the bezel from the long edge furthest away
from the controller ports and remove it from the Wii.
Remove
the two 5 mm Phillips screws above the controller ports. Use a metal spudger to
remove the three highlighted screw covers stuck to the side of the Wii.
Remove
the following screws:
Two
5 mm Phillips screws
One 8.2 mm Tri-Wing screw Use a metal spudger to remove the two rubber feet stuck to the bottom face of the Wii near the rear ports.
One 8.2 mm Tri-Wing screw Use a metal spudger to remove the two rubber feet stuck to the bottom face of the Wii near the rear ports.
Remove
the two 8.2 mm Tri-Wing screws hidden under the feet you just removed. Lift the
outer case straight up off the body of the Wii.
