Motorola Droid Pro: DISASSEMBLING PROCEDURE
Remove
the back cover and battery by using the thumb tabs.
Unscrew
the 8 back panel screws using the T4 Torx screwdriver.
Use
a spudger to open the phone along the sides between the back panel and the
chrome trim.
It
is held together by small clips that lock in. You may have to use a little
force to unlock them.
Go around on all sides then pull the back panel off.
Go around on all sides then pull the back panel off.
Gently
lift the SD & SIM card board (PCB) as shown in the following pictures. This
will expose the ribbon cable attached to the board and another ribbon cable for
the mother board. Remove them both using the spudger. Once the small one is
removed the small board can be pulled off.
Unscrew
the 6 screws using the T5 Torx screwdriver.
Unlock
the ribbon cable and then you can pull the screen out. When replacing screen
make sure you lock the ribbon cable back in place.
Pop
out key board using a spudger on the marked points. The keyboard is locked in
place, but can pop in and out. You may need to use a little force to get it
out. Once out you can pop the new keyboard in the opposite way you took it
out.
