LG Ally
VS740: DISASSEMBLING PROCEDURE
Hold
phone in hand, then flip to battery pack Take off battery cover
Remove
battery Locate the six surrounding screws located on the edge of the inner compartment,
including the two screws on the metal piece where the battery was once placed.
Slide
the phone open. Notice on the edges around the keyboard, there is a thick
casing. Remove this casing, instructions below… Placing two dominant fingers on
the back plate where the battery was, use your thumb finger nail (or prying
utensil) and place it on the edge of this thin casing. Firmly, push down with
your finger nail (prying utensil) around the casing from left to right.
Disconnect casing from keyboard section. Flip the phone over and remove it.
Using
your prying tool, lift the green circuit board platform off the black casing
and gently disconnect the connection point between the tether and the green
circuit board. Flip phone over, and notice where the camera lies on the other
side, there are three small clips connecting a black casing over the section of
the phone. Gently using your hands or the prying tool, take these clips off.
The
white rectangle with the yellow square is the flash. Gently lift up and disconnect
flash module. Take your new flash and aligning the connection point to the
connection hole, push it down firmly until it is snug in place. Follow the
steps backwards to put phone back together.
