Epson – EB-X14 – EB-S12B - EB-W12 – EB-X11
Replacing the Lamp
Lamp replacement period
It is time to replace the lamp when:
The following message is displayed.
"Time to replace the lamp.”
How to replace the lamp
The lamp can be replaced even when the projector is suspended from a ceiling.
1.After you turn off the projector's power and the confirmation buzzer beeps twice, disconnect the power cable.
2.Wait until the lamp has sufficiently cooled down, and then remove the lamp cover at the top of the projector.
Loosen the Lamp cover fixing screw with the screwdriver supplied with the new lamp unit or a Phillips screwdriver. Then slide the lamp cover straight forward and lift it to remove.
3. Loosen the two lamp fixing screws.
4. Take out the old Lamp by pulling the handle
5. Install the new lamp.
Insert the new Lamp along the guide rail in the correct direction so that it fits in place, push in firmly, and once it is fully inserted tighten the two screws.
6. Replace the lamp cover.
Resetting the lamp hours
The projector records how long the lamp is turned on and a message and indicator notify you when it is time to replace the lamp. After replacing the lamp, make sure you reset the Lamp Hours from the Reset menu.
Replacing the Air Filter
Air filter replacement period
If the message is displayed frequently even though the air filter has been
cleaned, replace the air filter.
How to replace the air filter
The air filter can be replaced even when the projector is suspended from a ceiling.
1. After you turn off the projector's power and the confirmation buzzer beeps twice, disconnect the power cable.
2. Open the air filter cover
3. Remove the air filter.
Grip the air filter cover tab and pull it straight out.
4. Install the new air filter.
Slide the air filter from the outside and press in until it firmly clicks into place.
5. Close the air filter cover.
Replacing the Lamp
Lamp replacement period
It is time to replace the lamp when:
The following message is displayed.
"Time to replace the lamp.”
How to replace the lamp
The lamp can be replaced even when the projector is suspended from a ceiling.
1.After you turn off the projector's power and the confirmation buzzer beeps twice, disconnect the power cable.
2.Wait until the lamp has sufficiently cooled down, and then remove the lamp cover at the top of the projector.
Loosen the Lamp cover fixing screw with the screwdriver supplied with the new lamp unit or a Phillips screwdriver. Then slide the lamp cover straight forward and lift it to remove.
3. Loosen the two lamp fixing screws.
4. Take out the old Lamp by pulling the handle
5. Install the new lamp.
Insert the new Lamp along the guide rail in the correct direction so that it fits in place, push in firmly, and once it is fully inserted tighten the two screws.
6. Replace the lamp cover.
Resetting the lamp hours
The projector records how long the lamp is turned on and a message and indicator notify you when it is time to replace the lamp. After replacing the lamp, make sure you reset the Lamp Hours from the Reset menu.
Replacing the Air Filter
Air filter replacement period
If the message is displayed frequently even though the air filter has been
cleaned, replace the air filter.
How to replace the air filter
The air filter can be replaced even when the projector is suspended from a ceiling.
1. After you turn off the projector's power and the confirmation buzzer beeps twice, disconnect the power cable.
2. Open the air filter cover
3. Remove the air filter.
Grip the air filter cover tab and pull it straight out.
4. Install the new air filter.
Slide the air filter from the outside and press in until it firmly clicks into place.
5. Close the air filter cover.
